Active balanced microphone- or line-level inputs.
18. Input 1 - 8 MIC/PHM/LINE 3-Position Slide Switch:
Selects operation at either microphonelevel (left), microphonelevel with 48 V phantom power (center), or linelev
el (right) signals. This switch is located behind the removable block connector.
SYSTEM SETUP
Rack mounting the SCM800/E
To mount an SCM800 or SCM800E in a standard 483 mm (19-inch) audio equipment rack so that the front panel
faces out, as shown in Figure 4. Then secure the mixer to the rack with the four supplied Phillips head screws.
RACK MOUNTING THE SCM800/E FIGURE 4
SCM800/E CONNECTIONS
Refer to Figure 5 and proceed as follows:
1. Connect microphone or linelevel signal sources to the Channel Input connectors (use conventional twocon
ductor shielded cables).
2. Insert a screwdriver or similar tool into the slot above each block connector and adjust the input slide switch as
required: microphone level (left position), 48 V phantom power (center position), or line level (right switch posi
tion).
3. Connect the Line Level Output of the SCM800/E to the input of other mixers, equalizers, amplifiers, or
recorders. If multiple SCM800/E mixers are to be used, refer to the Mixer Linking paragraph of this manual.
4. If headphone monitors are to be used, plug them into the ¼-inch PHONES jack on the front panel.
5. Connect the power cord to a 120 Vac (SCM800) or 230 Vac (SCM800E) power source.
Shure Incorporated
5/15