Setting The Clock - Samsung HHSM-G500005-1 Installation Manual

Cold Start
After carrying out the test function check the flow temperature of the system to ensure that the flow
temperature is above 10°C. If the flow temperature is below 10°C then the outdoor unit will not start.
Press the Timer button
pressor will start.
Put the system back into test mode by pushing and holding the left and right hand keys together for
6 seconds until either 7EST or Heat is shown on the controller.
1. If the system temperature is below 10°C turn on the immersion heater whilst the unit is on test mode
by pushing the Mode button
Turn on the pumps by pushing the Power
2.
on the controller.
Force the hot water valve open by pushing the Outing
3.
should appear. Leave the system to run like this until the flow temperature reaches 15°C.
4. Now Re-Check the Flow Meter to ensure that the flow rate is over 16 L/min. If the flow rate is
lower than 17L/min the unit will display a flow rate error "E911".
Once the flow temperature has reached 15°C, take the machine out of test by holding the Esc
5.
key.

Setting The Clock

To set the time push the User Set
1.
Push the Up
2.
Push the Right
3.
arrow to change the year and then push the Set
Push the Right
4.
Push the Right
5.
Push the Set button and 22 should flash, push the up button to change to 23.
6.
Push the Right
7.
button.
Push the right button and AM or PM will flash, use the up button to change to AM or PM, if you
8.
have both AM and PM flashing this will change the clock to 24 hours.
Push Right
9.
10. Push the Right
minutes. Now push the Set Key.
11. Push the Esc
to see the flow temp. This needs to be above 10°C before the com-
and the immserion should appear
arrow to change the 1 to a 2.
button twice and 21 should appear alonge with the year, use the Up
button and the month should flash, use the Up
button and the day should flash, use the up button to change.
arrow and the day and current time are shown, adjust the day with the Up
button and the hour will flash, use the Up
button and the minutes will flash, use the Up
button to return to the normal screen.
button and the pump symbol
button and the hot water symbol
button once and 1 should appear on the controller.
and 22 should appear.
Heat Pump Installation Guide
on the controller.
should appear
button to change.
button to change the hour.
button to change the
73