4
3
5
6
7
7
Place the clamp (3) in the loop
N
handle (4) and position them both
against the drive tube (5).
Place the clamp (6) against the
N
drive tube.
Place the barrier bar (2) in position
N
as shown.
Line up the holes.
N
Insert the screws (7) in the holes
N
and screw them into the barrier
bar (2) as far as stop.
Go to "Adjusting and Securing the
N
Loop Handle".
Leave the barrier bar permanently
mounted to the loop handle.
KM 56 R, KM 56 RC
Adjusting and Securing the Loop Handle
2
The loop handle can be adjusted to suit
the height and reach of the operator and
the application by changing
distance (A).
Securing the Loop Handle
N
Line up the loop handle.
N
Tighten down the screws firmly –
N
lock the nuts if necessary.
A
Carrying ring
The carrying ring is integrated in the
front end of the control handle.
English
9