Inserting The Mounting Seal - Siemens SIMATIC IFP2200 INOX MT ETH Compact Operating Instructions

Installing and connecting the device

3.2 Inserting the mounting seal

3.2 Inserting the mounting seal
To prevent the mounting seal from being inserted in the wrong direction, it has an
asymmetric coding tap. The coding tap is located at the bottom left of all mounting seals of
the INOX devices, relative to the rear of the device.
Note
Use a new mounting seal for each installation, because the promised degree of protection
cannot be guaranteed otherwise.
Procedure
1. Look for the coding tap on the mounting seal. Turn the mounting seal so that the coding
tap is on the bottom left as seen in the figure below:
①
②
③
18
Coding tap
Positioning hooks
Seal corner
Compact Operating Instructions, 03/2018, A5E42185570-AA
IFP2200 INOX MT ETH