Extended Storage - Stoelting 100CA Operator's Manual

A. DAILY
1. The exterior should be kept clean at all times to
preserve the lustre of the stainless steel. A mild
alkaline cleanser is recommended. Use a soft
cloth or sponge to apply the cleanser.
CAUTION
Acid-based cleaners, strong caustic compounds and
abrasive cleansers will damage plastic freezer parts and
exterior panels. Use mild, alkaline cleansers only.
2. Clean the sani-tray by lifting up,out,and rinsing and
replacing.
B. WEEKLY
1. Remove the sani-tray and cover. Clean behind the
drip tray with a soap solution.
2. Check all o-rings for excessive wear and replace if
necessary.
C. MONTHLY
CAUTION
The freezer has an air cooled condenser and must have
proper air circulation.
Do not place the floor model freezer any closer than six
(6) inches (15.2 cm) from the wall.
The counter model freezer requires a 3" (7.6 cm) clear-
ance on the sides, a 1" (2.5 cm) clearance at the rear, and
a 10" (25.4 cm) clearance at the top.
Failure to clean the condenser filter may result in serious
freezer damage and could void the warranty.
CONDENSER CLEANING
1. For the floor models, remove the sani-tray and
insert. Remove the two phillips head screws from
the lower front panel and pull panel down and out.
Blow the dirt out from the opposite side of the
condenser using an air tank, CO
2. For the counter model, remove the six phillips head
screws from the back panel. Then clean the con-
denser using the same method as on the floor model.
tank, or vacuum.
2
18

3.12 EXTENDED STORAGE

Refer to the following steps for storage of the freezer over
any long period of time:
A. Place the STIRRING ONLY-OFF-STIRRING &
FREEZING switch in the OFF position.
B. Disconnect (unplug) the freezer from the electrical
supply source.
C. With a warm detergent solution, thoroughly clean all
parts that come in contact with neutral base mix or
flavors. Rinse in clear water and dry all parts. Do not
sanitize.
Do not let cleaning solution or products stand in the
product cylinder during shutdown period.
D. Remove, disassemble and clean the spigot assem-
blies and lower bushing. Place these parts in a
plastic bag with a moist paper towel to prevent them
from becoming brittle.
NOTICE