WARNING
•
Use additional air hose if necessary to ensure
that the turbine is operated in a clean, dry, well
ventilated area.
•
Never place turbine inside a spray booth! Use
this equipment outdoors or in extremely well
ventilated areas.
•
Do not point gun at anyone or any part of the
body.
General Spraying Techniques
•
Select proper fluid set. To determine correct fluid set
see charts on page 8.
•
When fluid is first applied, start with fluid valve and
maximum air and the knob set to the FAN spray pat-
tern position. Then adjust as needed. See Fig. 8 for
pattern size adjustment.
•
Keep gun perpendicular to surface and maintain
consistent distance of approximately 6 to 8 inches
(150 to 200 mm) from object being sprayed. Fig. 15.
•
Always have spray gun in motion before triggering.
Move spray gun across workplace in straight,
smooth, stroke, maintaining speed and distance.
Release trigger at end of stroke.
•
To obtain an even finish, overlap previous strokes by
50%.
•
Apply full, wet coat whenever possible.
12
Spraying Techniques
Automotive Spraying
Techniques
•
When blending spots, work from outside in.
•
Two, 20-foot (6.1 m) hoses are recommended when
applying automotive finish coats. Additional hose
allows air to cool for better flow.
6 to 8 in.
(150 to 200 mm)
F
. 15
IG
Spraying Techniques
0793
RIGHT
0793
WRONG
309205R