Fiat Fullback Single cab Owner's Manual page 173

To shift from
2H
4H
4HLc
4HLc
4LLc
To shift from
2H
4H
4HLc
4HLc
4LLc
Setting of the drive mode-selector between "2H", "4H" and "4HLc" should only be done at speeds below 100 km/h.
During driving, never attempt to shift from "4HLc" to "4LLc". When shifting between "2H", "4H" and "4HLc" in cold weather
while the vehicle is in motion, the transfer gear may make some noise. In cold weather, try to shift the gear while the vehicle is
stopped. When shifting between "4LLc" and "4HLc", the transfer gear may make some noise.
When the drive mode-selector is set between "2H", "4H" and "4HLc" while the vehicle is stopped, the 2WD/4WD operation
indicator lamp blinks while the selection is in process. Drive slowly and normally after confirming that the lamp is illuminated.
(Refer to "2WD/4WD operation indicator lamp and low-range indicator lamp"). When the drive mode-selector is set between
"2H", "4H" and "4HLc" while the cruise control is activated, the transfer gear may make some noise.
When the drive mode-selector is set between "4HLc" and "4LLc" in cold weather, its selection may not complete. Return the
drive mode-selector to its previous position. After the engine is warmed up, make the range selection again.
135)
To
The drive mode-selector can be operated while the vehicle is either moving or
4H
stationary. When the vehicle is not in motion, shift the gearshift lever to the "N"
2H or 4HLc (Neutral) position before operating the drive mode-selector. When the vehicle is
moving, and only while it can be steered straight ahead, release the accelerator
4H
Stop the vehicle, depress the clutch pedal to the floor and operate the drive
4LLc
mode-selector. Keep depressing the clutch pedal while the 2WD/4WD operation
4HLc
To
The drive mode-selector can be operated while the vehicle is either moving or
4H
stationary. When the vehicle is not in motion, shift the selector lever to the "N"
(NEUTRAL) position before operating the drive mode-selector. When the vehicle is
2H or 4HLc
moving, and only while it can be steered straight ahead, shift the selector lever to the
"D" (DRIVE) position, and release the accelerator pedal before operating the drive
4H
Stop the vehicle, shift the selector lever to the "N" (NEUTRAL) position, and operate
4LLc
the drive mode-selector. If operation is made with the selector lever placed in any
other position than "N" (NEUTRAL) position, a gear noise may be generated, with a
4HLc
Procedure for vehicles with Manual Transmission
pedal before operating the drive mode-selector.
indicator lamp continues to blink.
Procedure for vehicles with Automatic Transmission
mode-selector.
possible failure to shift into a proper gear
171