Stopping The Engine - Fiat Fullback Single cab Owner's Manual

For vehicles equipped with the
keyless operation system
1. Fasten the seat belt.
2. Make sure the parking brake is
applied.
3. Press and hold the brake pedal
down firmly with your right foot.
NOTE When the engine is not started,
it may become hard to depress the
brake pedal and the vehicle may not be
able to detect the pedal operation.
Therefore the engine may not be
started. In such a case, depress the
brake pedal more firmly than usual.
4. On vehicles equipped with M/T,
depress the clutch pedal all the way
and place the gearshift lever in the "N"
(Neutral) position. On vehicles equipped
with A/T, make sure the selector lever is
in the "P" (PARK) position.
248
5. Press the engine switch. The diesel
preheat indicator lamp will first
illuminate, and then after a short time
go out, indicating that preheating is
completed. The engine will start.
NOTE If the engine is cold, the diesel
preheat indicator lamp is on for a longer
time.
NOTE Putting the operation mode in
ON will also start preheating the engine.
When the engine has not been started
within approximately 5 seconds after
the diesel preheat indicator lamp went
out, put the operation mode in OFF.
Then, attempt the engine start
procedure to preheat the engine again.
NOTE Minor noises may be heard on
engine startup. These will disappear as
the engine warms up.
NOTE Vehicles for specific Countries,
when ambient temperature is low even
after the engine has been warmed up,
and when the gearshift lever is put in
the "N" (Neutral) position (M/T) or the
selector lever is put in the "P" (PARK)
position or "N" (NEUTRAL) position
(A/T), the idling speed may increase. It
does not indicate a malfunction.

Stopping the engine

Except for vehicles equipped with
the keyless operation system
1. Bring the vehicle to a complete stop.
2. Fully engage the parking brake while
depressing the brake pedal.
AHA106593
3. For vehicles equipped with M/T, turn
the ignition switch to the "LOCK"
position to stop the engine, and then
move the gearshift lever to the 1st (on a
uphill) or "R" (Reverse) (on a downhill)
position. For vehicles equipped with
A/T, place the selector lever in the "P"
(PARK) position, and stop the engine.
For vehicles equipped with the
keyless operation system
226)
NOTE If you have to bring the engine to
an emergency stop while driving, press
and hold the engine switch for
3 seconds or more, or press it quickly
3 times or more. The engine will stop
and the operation mode will go to ACC.
NOTE Do not stop the engine with the
selector lever in any position other than
the "P" (PARK) position (A/T). If the
engine is stopped with the selector
lever in any position other than the "P"
(PARK) position, the operation mode
will go to ACC rather than OFF. Put the
operation mode in OFF after placing the
selector lever in the "P" (PARK) position.
1. Stop the vehicle
2. Fully engage the parking brake while
depressing the brake pedal.
3. On vehicles with M/T, press the
engine switch to stop the engine, move
the gearshift lever to the 1st (on a uphill)
or "R" (Reverse) (on a downhill) position.
On vehicles with A/T, move the selector
lever to the "P" (PARK) position, press
the engine switch to stop the engine.
151