Tool Use & Set Up; Operating Instructions; Nose Equipment - Stanley ProSet PB3400 Service Manual

3. Tool Use & Set up
The PB Series of tools are designed for installation of STANLEY Engineered Fastening Blind Fasteners.
DO NOT use under wet conditions or in presence of flammable liquids or gases.
READ ALL SAFETY WARNINGS AND INSTRUCTIONS BEFORE PUTTING TOOL INTO SERVICE.
Electrical Safety
The electric motor has been designed for one voltage only. Always check that the battery pack voltage
corresponds to the voltage on the rating plate. Also make sure that the voltage of your charger corresponds to
that of your mains.
Your DeWalt/POP-Avdel charger is double insulated in accordance with EN60335; therefore no earth
wire is required.
Using an Extension Cable
An extension cord should not be used unless absolutely necessary. Use an approved extension cable suitable
for the power input of your charger (see Technical Data). The minimum conductor size is 1 mm2; the
maximum length is 30 m.
When using a cable reel, always unwind the cable completely.
Before Use
• Select relevant size nose equipment and install
• Ensure that the battery is fully charged
• Insert Battery Pack into the tool
• Quickly pull and release the trigger to set the tool to the home position.

4. Operating Instructions

ALWAYS wear approved hearing and eye protection at all times when using installation
equipment
WARNING: Before adjusting tool, always remove the battery pack.

4.1. NOSE EQUIPMENT

Mounting the nosepiece (fig. 7).
• Select the correct nosepiece for the rivet to be installed. Ref. Nose Piece chart.
• Tighten the nosepiece (A) into the nose housing (B) by turning it clockwise using 23mm and 27mm or
14mm and 23mm spanner.
Mounting the jaw pusher and tail guide
• Select the correct jaw pusher or jaw pusher assembly (R) and Mandrel Guide (V) that matches the Nose
Piece selected. Ref. the Accessories Manual for appropriate nose equipment
12