Tool Use & Set Up - Stanley NB08PT-18 2.0 Ah Instruction Manual

E N G L I S H
3. TOOL USE & SET UP
The NB08PT-18 is designed for installation of STANLEY Engineered Fastening Blind Fasteners.
DO NOT use under wet conditions or in presence of flammable liquids or gases.
READ ALL SAFETY WARNINGS AND INSTRUCTIONS BEFORE PUTTING TOOL INTO SERVICE.
Electrical Safety
The electric motor has been designed for one voltage only. Always check that the battery pack voltage cor-
responds to the voltage on the rating plate. Also make sure that the voltage of your charger corresponds to
that of your mains.
Your DEWALT® charger is double insulated in accordance with EN60335; therefore no earth wire is
required.
Using an Extension Cable
An extension cord should not be used unless absolutely necessary. Use an approved extension cable suitable
for the power input of your charger (see Technical Data). The minimum conductor size is 1 mm
length is 30 m.
When using a cable reel, always unwind the cable completely.
Before Use
•
Select relevant size nose equipment and install
•
Ensure that the battery is fully charged
•
Insert Battery Pack into the tool
16
; the maximum
2