Memory Channel Deleting; Programmable Data In The Memory Channel - Alinco DR-620T/E Instruction Manual

Memory channel deleting

1.
Select the memory mode by pressing V/M key.
2.
Select the desired memory channel number by
rotating the main dial.
3.
The programmed memory channel has the
memory number illuminated on the display.
4.
By pressing M/W key together with FUNC key
while [F] icon is on, a beep will sound and the
memory will be deleted. At the same time,
[Memory No.] icon will start flashing.
NOTE:

Programmable data in the memory channel

Memory channel including 00 – 99, 100 – 39, CALL channel and AL channel can store following:
• Frequency
• Shift frequency
• Shift direction (+ / -)
• Tone encoder frequency
• Tone decoder frequency
• Tone encoder/decoder setting
• DCS encoder code
• DCS decoder code
• DCS setting
• Skip CH setting
• Busy channel Lock Out (BCLO)
• Digital mode setting
• Digital code
• Narrow mode setting
• AM mode setting
IMPORTANT: In PL/PH/AH, only frequency can be programmed.
When a LCD memory channel is flashing, the full contents of the memory are
displayed in the LCD.
After pressing FUNC key again, if you press M/W key while [F] icon is on, you can
restore a deleted memory. However, after changing CH or the mode, restoration
will not be possible.
Basic Operations
Memory Mode
21