Table of Contents
Advertisement
Doc Title
:
Product Data – User's Guide
Model
:
MBP28
2. The <SPEAKER MUTED ICON> will be displayed if the volume is turned off on the parent unit.
An audible alert will emit when you reach the highest or lowest volume level.
Changing the volume setting on the camera unit affects the volume when you use the Talk Back feature and when
playing a lullaby.
3.4
Talk Back
You can use the Talk Back feature to comfort and reassure your baby.
During Talk Back, you will not be able to hear your baby until you release <TALK>.
1. Press and hold <TALK> on the parent unit to speak to your baby. Talk will be displayed on the parent unit.
2. Release to hear your baby again.
3.4.1
Adjust talk back volume
The camera unit has 5 volume levels from Level 1 to Level 5.
Press < > or < > on the camera unit to increase or decrease the volume respectively.
NOTE
If a lullaby is playing, it will stop during Talk Back, but will restart from the beginning when the Talk Back ends.
3.5
Temperature
The camera unit constantly monitors the temperature in your baby's room and alerts you if it gets lower than 14°C
(or 57°F), by emitting a warning beep and showing the alert message "Too cold! from Baby Unit x" on the parent
unit screen, or if it gets higher than 39°C (or 102°F), it will show "Too hot! from Baby Unit x". Although this is for
reference only, and there may be a small difference between the baby monitor reading and the actual temperature,
please check your baby immediately if such an alert message is triggered.
NOTE
The current temperature at the camera unit is shown on the parent unit status bar whenever it is displayed.
3.6
Lullaby
There are 3 lullabies available to play for your baby, either repeating one lullaby or repeating through all three
lullabies.
1. Press <LULLABY> on the camera unit to select the lullaby and start playing when the camera is linked with the
parent unit.
2. During playback, press <LULLABY> to step through different lullabies.
OR
Press <PLAY> on the camera unit to start playing the selected lullaby.
4. During playback, press <STOP> to stop playback.
NOTE
Once the camera unit loses the link with the parent unit, the lullaby playing will be stopped and will not be resumed
automatically even if the link is set up again.
3.7
Switch monitoring camera unit
The system allows registering up to four camera units. You can switch the monitoring camera unit by one-touch key
or by menu settings.
By one-touch key:
Press <POWER/BACK> on the parent unit when it is in video monitoring mode. The parent unit will switch to the
next registered camera unit to monitor your baby. After that, you can switch to other registered camera units by
further pressing <POWER/BACK> if necessary, with each registered camera unit being selected in turn.
By menu settings:
The system also allows the parent unit to be set to automatically switch among all the camera units, with each
registered camera unit being selected in turn at about 30 second intervals. Refer to section 4.6 for the instructions
of scanning all camera units automatically.
This document contains confidential and proprietary information of VTech Telecommunications Ltd
Revision :
Page(s) :
R.00
10 of 17
Advertisement
Table of Contents
