VTech ErisTerminal VSP610A ErisTerminal VSP608A User Manual page 16

To install the base station:
1. Plug one end of the Ethernet cable into the Ethernet port on the rear of the
base station (marked by
network router or switch.
2. If the base station is not using power from a PoE-capable network router or
switch:
a. Connect a compatible VTech power adapter to the power jack.
b. Plug the power adapter into an electrical outlet that is not controlled by a
wall switch.
IMPORTANT INFORMATION
1. Use only a compatible VTech power adapter with this product.
2. The power adapter is intended to be correctly oriented in a vertical or floor
mount position. The prongs are not designed to hold the plug in place if it is
plugged into a ceiling, under-the-table or cabinet outlet.
To mount the base station on a wall:
1. Install two mounting screws on the wall. Choose screws with heads larger
than 5 mm (3/16 inch) in diameter (1 cm / 7/16 inch diameter maximum). The
screw centers should be 5 cm (1 15/16 inches) apart
vertically or horizontally.
2. Tighten screws until only 3 mm (1/8 inch) of the
screws are exposed.
), and plug the other end of the cable into your
Use only
Supplied
Adapter
RESET
16