Cooling Fan Connector
[Figure
2-1, callout 45]
The XCZU9EG U1 cooling fan connector is shown in
ZCU102 is powered up.
X-Ref Target - Figure 3-39
VADJ_FMC Power Rail
The ZCU102 evaluation board implements the ANSI/VITA 57.1 section 5.5.1 IPMI support
functionality. The power control of the V
controller. This rail powers both the FMC HPC0 (J5) and the FMC HPC1 (J4) V
as the XCZU9EG HP banks 65, 66 and 67. The valid values of the V
and 1.8V.
At power on, the system controller detects if an FMC module is connected to each interface:
•
If no cards are attached to the FMC ports, the V
•
When one FMC card is attached, its IIC EEPROM is read to find a V
supported by both the ZCU102 board and the FMC module, within the available
choices of 1.8V, 1.5V, 1.2V, and 0.0V.
•
When two FMC cards are attached with differing V
the lowest value compatible with the ZCU102 board and the FMC modules, within the
available choices of 1.8V, 1.5V, 1.2V, and 0.0V.
•
If no valid information is found in an FMC card IIC EEPROM, the V
0.0V.
ZCU102 Evaluation Board User Guide
UG1182 (v1.2) March 20, 2017
Figure 3-39: ZCU102 12V Fan Header
power rail is managed by the U41 system
ADJ_FMC
www.xilinx.com
Chapter 3:
Board Component Descriptions
Figure
3-39. The fan turns on when the
rail are 1.2V, 1.5V,
ADJ_FMC
voltage is set to 1.8V.
ADJ
ADJ
requirements, V
ADJ
ADJ_FMC
Send Feedback
pins, as well
ADJ
voltage
is set to
ADJ_FMC
rail is set to
104