Change Pin; Dial Mode; Flash Time - Grundig GDT 400 User Manual

22
BASE SETTING

Change PIN

PIN is your base's identification number, the function is to avoid the setting is
changed by others. The default setting is "0000". You may change the PIN.
Please take down the change so as to operate the unit normally.
1.
Press » « key.
2.
Press »+« or »–« key to select "BS SETTINGS" and press »
3. "INPUT PIN" will be shown, input the correct PIN code and press
» « key.
4.
Press »+« or »–« key to select "CHANGE PIN" and press »
LCD will show "NEW PIN".
5.
Press number key to input the new PIN code and press »
LCD will show "CONFIRM PIN", prompt you to input the new PIN code
again.
6.
Input the new PIN code again and press »
ting.
Note:
1. The PIN code must be 4 digits.
2. If the new PIN code that you input two times is different, the change will fail,
the display will return to step 4.

Dial Mode

You may set the dial mode to "TONE" or "PULSE". The default setting is
"TONE".
1.
Press » « key.
2.
Press »+« or »–« key to select "BS SETTINGS" and press »
3. "INPUT PIN" will be shown, Input the correct PIN code and press
» « key.
4.
Press »+« or »–« key to select "DIAL MODE" and press »
5.
Press »+« or »–« key to select "TONE" or "PULSE".
6.
Press » « key to confirm the setting.

Flash Time

You may select flash time according to your needs.
1.
Press » « key.
2.
Press »+« or »–« key to select "BS SETTINGS" and press »
3.
"INPUT PIN" will be shown, Input the correct PIN code and press »
key.
4.
Press »+« or »–« key to select "FLASH TIME" and press »
5.
Press »+« or »–« key to select the desired flash time.
6.
Press » « key to confirm the setting.
« key.
« key, the
« key, the
« key to confirm the set-
« key.
« key.
« key.
« key.
«