Ford Ranger 2019 Owner's Manual page 127

E188212
3. Press and hold the function button you
want to program for 2 seconds, then
release. Repeat this step. Depending
on your brand of garage door opener,
you may need to repeat this sequence
a third time.
Gate Operator / Canadian
Programming
Canadian radio-frequency laws require
transmitter signals to "time-out" (or quit)
after several seconds of transmission –
which may not be long enough for
HomeLink to pick up the signal during
programming. Similar to this Canadian law,
some U.S. gate operators are designed to
"time-out" in the same manner.
Note: If programming a garage door opener
or gate operator, it is advised to unplug the
device during the "cycling" process to
prevent possible overheating.
1. Press and release, every two seconds,
your hand-held transmitter until the
HomeLink indicator light changes to a
rapidly blinking or continuously on light.
2. Release the hand-held transmitter
button.
3. Continue programing HomeLink. See
In-Vehicle Programming, Step 4.
Erasing the Function Button Codes
Note: You cannot erase individual buttons.
Ranger (TFG) Canada/United States of America, enUSA, Edition date: 201809, First-Printing
Garage Door Opener
1.
2. When the indicator light flashes,
Reprogramming a Single Button
To program a device to a previously trained
button, follow these steps:
1.
2. The indicator light begins to flash after
For questions or comments, contact
HomeLink at www.homelink.com,
www.youtube.com/user/HomeLinkGentex
or by calling the toll-free help line at
1-800-355-3515.
124
E188213
Press and hold the outer two function
buttons simultaneously for
approximately 10 seconds until the
indicator light above the buttons
flashes rapidly.
release the buttons. You erased the
codes for all buttons.
Press and hold the desired button. Do
NOT release the button.
20 seconds. Without releasing the
button, follow Step 1 in the
Programming section.