Fcc Requirements - BellSouth GH9640 Owner's Manual

FCC Requirements

Federal Communications Commission Requirements
This equipment complies with Part 68 of the FCC rules. A label on the BASE UNIT of the equipment
contains, among other information, the FCC Registration Number and the ringer equivalence number
(REN) for this equipment, You must, upon request, provide this information to your telephone
company.
The REN is also useful in determining the number of devices that you may connect to your telephone
line and still allow all of these devices to ring when your telephone number is called. In most, bust
not all areas, the sum of the RENS of all devices connected to one line should not exceed five
(5.0) .To be certain of the number of devices that you may connect to your line, contact your local
telephone company.
If your equipment should cause harm to the telephone network, the telephone company may
temporarily disconnect your service. If possible, they will notify you in advance that temporarily
discontinue of service may be required.
However, when advance written notice is not possible, the telephone company may temporarily
discontinue service without notice if such action is necessary under the circumstances, The
telephone company may make changes in its communication facilities, equipment, operations or
procedures where such action is reasonably required in the operation of its business and is not
inconsistent with the rules and regulations of the Federal Communications Commission.
Do not attempt to repair of modify this equipment.
Warning: Changes of modifications not expressly approved by the party responsible for its
compliance could void the user's authority to operate the equipment.
Some cordless telephones operate at frequencies that may cause interference to nearby TV's and
VCR's. To minimize or prevent such interference, the BASE UNIT of the cordless telephone should
not be placed on or near a TV or VCR. If interference is experienced, moving the cordless telephone
farther away from the TV of VCR will often reduce of eliminate the interference.
This equipment should not be used on coin telephone lines, Connection to party line service is
subject to state tariffs. If trouble is experienced, disconnect this equipment from the telephone line to
determine if it is causing the malfunction, If the equipment is determined to be malfunctioning, its use
should be discontinued until the problem has been corrected.
IMPORTANT
Placing your BASE UNIT near appliances such as
television, refrigerators radio, or microwave oven may
cause interference.
FCC Requirements
Federal Communications Commission Requirements (continued)
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules, These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in accordance with the
instruction, may cause harmful interference to radio communication. However, there is no guarantee
that interference will not occur in a particular installation .If the equipment does cause harmful
interference to radio or television reception , which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
- Reorient or relocate the receiving ANTENNA.
- Increase the distance between the equipment and the receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subjected to the following two
conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received including interference that may cause
undesired operation.