Table of Contents
Advertisement
Figure 21: Auto Selection Management
Highlight the profiles to add to auto profile selection, and click Add. The
3.
profile will appear in the Auto Selected Profiles box.
Highlight a profile in the Auto Selected Profiles box.
4.
Click Move Up or Move Down as appropriate.
5.
The first profile in the Auto Selected Profiles box has highest priority,
N
:
OTE
while the last profile has the lowest priority.
Click OK.
6.
Check the Auto Select Profiles checkbox on the Profile Management tab
7.
(shown in
Figure 12 on page
When auto profile selection is enabled by checking Auto Select
N
:
OTE
Profiles on the Profile Management tab, the client adapter will scan for an
available network. The profile with the highest priority and the same SSID
as one of the found networks will be used to connect to the network. If the
connection fails, the client adapter will try the next highest priority profile
that matches the SSID until an available network is found.
– 29 –
| Configuration Guide
C
3
HAPTER
22).
Profile Management
Advertisement
Table of Contents
