Wireless Pin Cloning Radios - Motorola DLR1060 User Manual

• Press the PTT button and the (-) button
simultaneously while turning the radio
ON.
• Wait for 3 seconds before releasing the
buttons until the audible tone and voice
announcement "Clone Mode Serial" are
heard.
3. Place the Source radio in the source pocket that
pairs with the target pocket you chose in step 1.
Press and release the (+) button.
4. After cloning is completed, the Source radio will
announce either "successful" (cloning is
successful) or "fail" (cloning has failed).
5. Once you have completed the cloning process,
turn the radios OFF and ON or, long press the
PTT button to exit the 'cloning' mode.
Further details on how to clone radios are
explained in the Instructions Sheet provided
with the MUC.
When ordering the MUC, refer to P/N#
PMLN7135_.
Notes:
• If cloning fails, refer to "What To Do If Cloning
Fails" on page 47.
• Paired Target radios and Source radios must be
of the same band type in order for the cloning to
run successfully.
• MUC pockets numbers should be read from left to
right with the Motorola logo facing front.

Wireless PIN Cloning Radios

To clone radios using the Wireless Pin Cloning
method:
1. Power the Source radio following the sequence
below:
• Press the PTT button and the (-) button
simultaneously while turning the radio
ON.
• Wait for 3 seconds before releasing the
buttons until the audible tone and voice
announcement "Clone Mode Serial" are
heard.
• Press and release the (-) button and the
Source Radio will announce "Wireless".
43
English