Before Use - TAGSON PS-2/ES English Manual

5. ADJUSTING LASER MARKER
Tagson PS-2/ES machine has two laser markers installed on the IndES module.
With laser markers you can point where needles hit cards.
→ Turn off air supply with the Main switch
→ Install the card with product under the machine.
→ Manually push the IndES module down by hand until the needles touch the card and
leave holes in the card.
→ Do not move the card while pushing the machine up to its highest position.
→ Turn on air supply with the Main switch.
→ Gently turn the laser screw
are.
→ Carefully tighten the screw
→ Make a test on the card without a product.
WARNING! Do not look directly into the laser. It might cause eye injuries.
NOTE: Turn the screws gently. Settings are extremely sensitive.

Before use

WARNING! Module needles are sharp. Use caution when removing and replacing
needles, and during operation. Discard needles that are damaged or have punctured the
skin.
Before starting, the following steps should be double checked:
→ Air supply: filter regulator on the machine must be 80 psi (5,5 bar).
→ Clear the working area.
CAUTION: Always wear protective glasses to prevent eye injuries, and keep hands away
from the working area during operation.
How it works:
To complete the operation, machine has 3 cycles:
→ CYCLE A: By pressing and holding finger switches
→ CYCLE B: When the module is at its lowest position, the machine activates the ejector
rod and ejects an elastic staple.
→ CYCLE C: By releasing finger switches
NOTE: In order to activate cycle A, press finger switches with both hands at the same time.
.
and adjust the laser marker to where holes on the card
so that the laser marker does not move.
, the module goes down.
, the module goes up.
13