Indes Avery Dennison Module; Working With The Machine - TAGSON PS-2/ES English Manual

IndES Avery Dennison module

TAGSON PS-2/ES has a built-in IndES Avery Dennison module
that runs staples through the power unit. It is pneumatically operated, do not try to apply more than
80 psi (5,5 bar) into the machine.
NOTE: Before operating with the machine, please read safety and manual instructions for the
IndES Avery Dennison Fastening System module.

Working with the machine

This chapter explains how to operate the Tagson Pack & Tag machine.
NOTE: Before operating, please check the air supply level. Air supply must be 80psi (5,5 bar).
WARNING! Always turn off air supply whenever the unit is not in use, or when servicing the
machine.
1. LOADING FASTENERS
With staple loaded to the Module Assembly:
Air Supply should be ON
1. Cut the staple chain rails just below a rung on the staple chain.
2. Insert one side of the staple chain into the opening in the feed system.
3. Insert the other side of the staple chain into the other opening in the feed system.
4. Push one side of the staple chain down until the bottom rung engages the anti-back.
10
. The module is the main device