Process Variables - Siemens Sitrans P500 Operating Instructions Manual

Operate
6.2 Parameter description
Menu entry Designation
Sensor
3.2.6.10
•
Sensor Serial No
– 3.2.6.10.1
Sensor Order Number
– 3.2.6.10.2
Module Range Code
– 3.2.6.10.3
Lower Range Limit
– 3.2.6.10.4
Upper Range Limit
– 3.2.6.10.5
Minimal Span
– 3.2.6.10.6
Firmware SENSOR
– 3.2.6.10.7
3.2.7 Firmware Device
3.2.8 Hardware Device
in accordance with the order
1)
in accordance with the measuring cell selection/ device manufacture
2)
Max. +10 % depending on the installation position, sensor trim
3)
6.2.4.3

"3.3 Process Variables"

"3.3.1 Current Out"
Display:
Purpose:
Description:
"3.3.2 ... 3.3.10 User"
The menus show the measured value in the unit you selected.
Menu entry
3.3.2
3.3.3
•
•
•
3.3.4
•
•
124
Adjusta-
3,55 ... 23 mA
Displays the output current
This parameter shows the current digital value of the output current. For
deviations from the analog output current, use the function "2.4.3.1 DA-
Converter" (Page 106).
Designation
PV Percent Range
Pressure
Untrimmed Pressure
3.3.3.1
Static Pressure
3.3.3.2
Pressure
3.3.3.3
Temperature
Sensor Temperature
3.3.4.1
Electronic Temperature
3.3.4.2
Pre-set Factory setting
ble
- X in accordance with the measuring cell selection/
device manufacture
- X
e.g. 7MF5944-1DA1
- X
e.g. -250...250 mbar
- X
e.g. -250 mbar
- X
e.g. 250 mbar
- X
e.g. 1.25 mbar at 250 mbar
- X
in accordance with the measuring cell selection/
device manufacture
- X in accordance with the measuring cell selection/
device manufacture
- X in accordance with the measuring cell selection/
device manufacture
1)
1)
2)3)
2)3)
2)
SITRANS P500 with HART
Operating Instructions, 12/2014, A5E02344528-09