Table of Contents
Advertisement
The LCD will show "Updating Panel Please Wait..." and exit the installer menu.
For New South Wales, Victoria, South Australia, Tasmania, and the Australian Capital
Territory:
Explanation: See table below
1479* is used to enter INSTALLER MENU, # at the end is used to exit the INSTALLER MENU.
Location
The LCD will show "Updating Panel Please Wait..." and exit the installer menu.
Step 4 - Exit Delay (Location 230)
Default value: 30 seconds. Ignore if don't need to change.
Example:
seconds.
Step 5 - Primary Entry Delay (Location 231)
Default value: 30 seconds. Ignore if don't need to change.
Example:
seconds.
Step 6 - Setting Siren Time Out Period (Location 17)
Default value: 2 minutes. Ignore if don't need to change.
Example:
Warning: It is an offence for an intruder alarm to be heard in any neighbouring residence
when it sounds for more than: 5 minutes if installed on or after 1 December 1997 NSW.
Copyright © Cornick Pty. Ltd. 2018
Enter:
1479* 25* 10* 26* 7* 27* 1* 28* 4* 29* 7* 30* 1* 31* 60* #
25
Daylight Start Month
26
Daylight Start Day
27
Daylight Start Week
28
Daylight End Month
29
Daylight End Day
30
Daylight End Week
31
Daylight Offset
Enter:
1479* 230* [Partition Number]* [mmss] *##
1479* 230* 1* 0100* ##
Enter:
1479* 231* [Partition Number]* [mmss] *##
1479* 231* 1* 0100* ##
Enter:
1479* 17* [Siren Time]* [mmss] *#
1479* 17* 0130* #
sets siren time to 1 minute 30 seconds.
Field
sets exit delay of Partition 1 (Zone1-8) to 1 minute 0
sets entry delay of Partition 1 (Zone1-8) to 1 minute 0
Value
10 (October)
7 (Sunday)
1 (First week)
4 (April)
7 (Sunday)
1 (First week)
60 (60 minutes)
Page 5
Advertisement
Table of Contents
