Panasonic BB-HCM403A Installation Manual

Installation Guide

(For Professional Installers)
Network Camera
BB-HCM403A
Model No.
•
Installation and wiring should be performed by a professional installer.
•
Install the camera after camera is connected and setup is finished following the Getting Started guide.

Installation Procedures

Adjust the position and
direction of the camera.
Attach the camera.
•
The camera can be viewed in the least light requirement at 3 lx (default). Use supplemental lighting for the dimly lit places.
The camera can be viewed in the least of 0.2 lx in the color night view mode (see page 70 of the Operating Instructions on
the CD-ROM), which may increase the refresh interval.
•
After preparing the Ethernet cable that has enough length, mount the camera.
•
Mounting and cabling instructions described in this Installation Guide follow generally accepted guidelines suitable for residential
installations. In some areas, commercial and industrial installations are regulated by local or state ordinances. For such installations,
contact your local building department or building inspector for more details.

Mounting on the Ceiling

Two ways of wiring the cables (Ethernet cable, AC adaptor
cord, etc.) can be considered; wiring through a hole made
in the ceiling or wiring without making a hole in the ceiling.
Select either one of the two.
Note
•
Make sure to mount the camera firmly on the ceiling.
•
Do not mount the camera on a weak ceiling.
•
It is necessary to attach the Safety Wire so that the camera does
not fall.
•
The Ceiling Mounting Cover should be removed when removing
the SD memory card (see page 127 of the Operating Instructions
on the CD-ROM).
•
The camera is intended for indoor ceiling use only. Prolonged
exposure to direct sunlight or halogen light may damage CCD.
•
The camera's MAC address and serial number are printed on the
bottom of the camera. They are needed in order for camera
configuration and maintenance. Record both of them for before
mounting the camera.
PQQX15558ZA
KK0606JT0
Indoor Ceiling Use Only
(PoE Ready)
Adjust the position and direction of the camera while you confirm that
images are displayed on the monitor as you imaged.
Attach the camera firmly when mounting on the ceiling.
•
Please read the Important Information before using.
•
"Network Camera" is called "Camera" in this manual.
•
"Setup CD-ROM" is called "CD-ROM" in this manual.
Mounting Reference Diagram (Bottom View)
Wiring through a hole made in the ceiling
1
Attach the Safety Wire to the camera with Screw B and
Washer (S).
© 2006 Panasonic Communications Co., Ltd. All Rights Reserved.
Screw B
Washer (S)
Safety Wire