Advertisement
Viewing a Presentation using WebShare
WebShare allows audience members to view a presentation on their computers or mobile devices through a web browser. The
presenter may broadcast the presentation so that the image shown on the display can be viewed remotely.
Audience members must follow these steps to watch the presentation:
Open a web browser on the mobile device or computer and enter the
1.
IP address of the ShareLink Pro 1000. The landing page opens as
shown at right.
Click View in WebShare
2.
The presentation page opens in the web browser.
Moderating a Presentation
A moderator can accept or decline participants, stop shared content, and remove active participants from a session.
NOTE:
The following instructions apply only when the ShareLink Pro is set to "Run-Time" mode, which is the default setting.
If the device is set to a different mode, see the ShareLink Pro 1000 User Guide for instructions.
To moderate the session:
Open the software menu by clicking the menu icon (see
1.
Click Enable Moderate. The Manage tab appears on the software menu as shown below:
2.
1
1
Participant tab - Use this section to manage session participants as follows:
Pending panel (left): Accept or decline pending participants listed in this panel.
•
Connected panel (right): Disconnect current participants by clicking Disconnect next to the applicable
•
participant.
2
Content tab - Use this section to stop the current presentation or content.
©
2018 Extron Electronics All rights reserved. All trademarks mentioned are the property of their respective owners.
(see
1
at right).
TM
2
TM
1
1
at right), and click Moderate (
1
2
).
2
68-3353-50
www.extron.com
Rev. A
10 18
6
Advertisement
