Calibration Gas Value; Serial Number And Firmware Version; Exit - Emerson Net Safety Millennium II Reference Manual

Programming
June 2016
4.18

Calibration gas value

This option allows the user to select the calibration gas value in the transmitter main menu. Although it
is recommended that 50% span gas should be used for calibration, for some sensors, the transmitter
will allow tolerance/flexibility in the calibration gas available; 10% to 60% span gas allowed for some
sensor types. See specific sensor manual.
1.
2.
3.
4.
5.
4.19

Serial number and firmware version

This option is used when the serial number or firmware version of the Millennium II Transmitter is
required.
1.
2.
3.
4.
4.20

Exit

This option allows the user to exit the menu system and return to the normal operation mode.
24
Enter the main menu by activating any key to get the "enter main menu" prompt, then activate
switch 1 to select "yes".
Activate the up key (switch 1) or down key (switch 2), until "Cal. Gas value" option is displayed.
Activate the enter key (switch 3). Channel1 and channel 2 existing calibration gas values will be
displayed in three numeric groups: 'hundreds', 'tens', and 'ones'. For example: 0 5 0 indicates a
calibration gas value of 50% span.
Highlight the required channel with calibration gas value using the navigation keys (switch1) or
(switch 2), then select using switch 3. Switch 1 is used to increase /change a value in each
numeric group, while switch 2 is used to cycle across the numeric groups.
To exit, select "Exit" at each menu stage (sub menu and main menu).
Enter the main menu by activating any key to get the "enter main menu" prompt, then activate
switch 1 to select "yes".
Activate the up key (switch 1) or down key (switch 2), until "Serial Number and Firmware
Version" option is displayed.
Activate the enter key (switch 3). The firmware version and serial number will be displayed.
To exit, select "Exit" at each menu stage (sub menu and main menu).
Reference Manual
MAN-0076, Revision 09
Programming