Adjustment; Adjustment At Time Of Parts Replacement - Canon imageRUNNER iR2270 Service Manual

4.2 Adjustment

4.2.1 Adjustment at Time of
Parts Replacement
4.2.1.1
Adjustments
Replacing the Finisher
Controller PCB
1.Setting the Type of Punch Unit Hole (W/
punch unit connected)
1）Set the DIP switch (SW1) as follows:
1
2
3
4
*1: 1 cycle of flashing consists of ON for
300 msec and then OFF for 200 msec.
3) When the desired type is selected, hold
down the push switch so that the LED will
remain on, indicating that the selected type
has been registered in EEPROM.
4) Put the push switch (SW2) back to its
original setting, and turn off and then on
the power.
Making
When
0008-1418
LED
flashes once and goes off*1
flashes 2 times and goes off*1
flashes 3 times and goes off*1
flashes 4 times and goes off*1
ON
1 2 3 4
F-4-2
2）Then, select the type of punch unit by
the push switch (SW2). Each press on the
push switch will cause the indication to
change repeatedly from 1 to 4 shown in the
table.
T-4-2
4-hole unit (French)
2/3-hole unit
4-hole unit (Sweden)
Chapter 4
Unit type
2-hole unit
4-3