Part Ii: Install Lock Case Assembly - Kaba Mas Cencon MDB 30N Installation Instructions Manual

P II: I
ART NSTALL
WARNING: Do not take the lock case assembly apart. This action will
void the lock warranty.
1. Ensure the cables lay in the cable channel as you mount the lock case
assembly to the inside of the container door using the three 1/4-20
(or M6-1) screws (Torque 25-30 lbs., 2.8-3.4 N-M), allowing 1/20" (1.27mm)
clearance between the lock bolt and the container locking bar.
Note: The lock case assembly can be mounted in all orientations for all
mounting locations. It is recommended that you use Loctite® 262 (Red)
on the lock case mounting screws.
Figure 3 - Mounting Stud Alignment
L C
OCK ASE
Figure 5
6
A
SSEMBLY