Cencon Lock Lcd Terminology - Kaba Mas Cencon MDB 30N Installation Instructions Manual

Previous to a lock being activated in any mode, the prompts ##, #4, and #70, 72, 76,
78 and 79 will display the error. #72 only applies to Gen2 locks activated with a USB
Key Box.
After a particular mode is shelved, the ## and #4 prompts will still display "" to give
information about a mode the last time it was active, though the remaining #7x
prompts mentioned will start showing the error again.
The irst step in learning the operation of the Cencon Lock is understanding what is
shown on the display.
Note: The Cencon LCD uses a 7-segment font, displaying up to 3 characters
at a time. Some displays will be a mixture of numbers and both capital and
lower case letters.
Lock Displays/Prompts Used on Swing Bolt Gen2
1. = DL Dial briskly in either direction to power the lock.
2. = EC Enter Combination
3. = OPr Turn bolt handle to open the container door.
4. = CLb (Change Key Function Activated)
5. = Enter Current combination (Shelved mode/Factory)
6. = Enter New combination (Shelved mode/Factory mode)
7. = Conirm New combination (Shelved mode/Factory mode)
8. = Lightning Bolt (Error); usually wrong combination
9. = LockOut condition due to 5 lightning bolts
10. = Insert Personal Identiier (key) 1
11. = Close Seal number (where 0 is a number)
12. = EOP (End Of Process)
13. = "?" displayed when the command key (#) is pressed
14. = (##) - Seal Count** for an active mode by user key
15. = (##) - Seal count** for a Shelved mode by user key
16. = (#1) - Lock irmware code Level
17. = (#1) - Hardware Level of lock back cover
18. = (#2) - Serial Number of lock back cover
19. = (#3) - Total (All modes) opening Count
**Seal count, Opening Count, and Audit Count are terms used
interchangeably throughout the documentation.
21. = Indicates Gen2 lock during power-up
22. = Remote Lock Out signal; keypad entry is prevented
23. = (#71) - UTC/GMT date and time of lock
24. = (#71) - Date, starting with Year, then Month, then Day
25. = (#71) - Time, starting with Hour, then Minute, then Second
26. = (#73) - Cencon iButton (key) Model Number
27. = (#73) - Cencon iButton (key) Serial Number
28. = (#74) - OPened Door
29. = (#74) - CLosed Door
30. = (#74) - No door Contact Connection
31. = (#77) - UTC/GMT date and time on Personal Identiier Key's Clock
For a full listing of Lock LCD Terminology, including displays only shown while the
lock is activated, refer to the Cencon 5 Software Reference Manual, Appendix C.

Cencon Lock LCD Terminology

12