Basic Lock Operations; Opening In Shelved Mode - Kaba Mas Cencon MDB 30N Installation Instructions Manual

B L
ASIC OCK
For the complete Cencon lock and software operating instructions in FLM, Route,
and Bank modes, please see the Cencon Reference Manual on the documentation
section at www.kaba-mas.com.
Each lock is shipped from the factory in Shelved Mode. The "one time only"
combination feature is not available when the lock is shelved. Instead, the
Shelved Mode combination is used to open the lock. The default Factory
Combination is set to 50-25-50. The default combination may be changed,
in which case the new combination would be used to open the lock while in
Shelved Mode. The correct opening procedure for a shelved lock is:
1. Press * Key → EC
Press * key until the letters EC (Enter Combination) appear in the display
window.
2. EC → Enter Shelved Mode Combination → OPn
Enter the current Shelved Mode combination, whether it be the Factory
Combination of 50-25-50 or a new Shelved Mode combination, by sequentially
pressing those digits on the lock keypad. The lock will display the numbers as
the combination is entered. When the combination has been correctly
entered, the bolt will begin moving to open the lock and the lock will display "---"
while the bolt is moving. The bolt will stop moving when it reaches the
open position and the lock will display OPn. The lock will proceed from OPn to
CLo steps automatically if the lock bolt works hasn't been retracted
within the OPn timeout.
3. OPn → Retract Bolt
Rotate the container handle to to unlock the lock, and the lock display will
be cleared.
4. Open Container Door
5. Close Container Door
6. Extend Bolt → CLo Rotate the container handle to extend the bolt. The lock will
display "---" while the bolt is moving. The bolt will stop moving when it
reaches the closed position and the lock will display CLo.
O
PERATIONS
Opening Lock in Shelved Mode
9