Introduction - Kaba Mas Cencon MDB 30N Installation Instructions Manual

Please read all instructions carefully before you install and use your Cencon ATM
Security Lock. This will help you avoid unnecessary costs and concerns resulting
from improper installation.
The installation instructions are the basis for Security Agency Approvals. The lock
installation must be done in accordance to these instructions in order to maintain
the labeled approval level.
In order to maintain VdS Class 2/EN 1300 Class B lock approval levels in a container where multiple locks are
required, special considerations must be observed. The lock must be the irst one secured by the boltworks.
Check the locked status of the container with the handle of the boltworks.
Notice: The audit features, the software features associated with peripheral devices and systems, the optional USB
interconnect box and its associated features, features involving the use of user keys, Bluetooth functionality and
other additional features have not been evaluated by UL. The lock was also not evaluated by UL for 24V operation.
FCC INFORMATION
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause
undesired operation.
Changes or modiications made by the user and not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment. NOTE: This equipment has been tested
and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
IC INFORMATION
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the
following two conditions: (1) this device may not cause interference, and (2) this device must accept any
interference, including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts
de license. L'exploitation est autorisée aux deux conditions suivantes: (1) l'appareil ne doit pas produire
de brouillage, et (2) l'utilisateur de appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d'en compromettre le fonctionnement.
RF EXPOSURE
This equipment complies with radiation exposure limits set forth for an uncontrolled environment. This
equipment should be installed and operated with minimum distance of 20 cm between the radiator and
your body. This transmitter must not be co-located or operating in conjunction with any other antenna or
transmitter.
"Cet équipement est conforme aux limites d'exposition aux radiations dans un environnement non contrôlé.
Cet équipement doit être installé et utilisé à distance minimum de 20 cm entre le radiateur et votre corps. Cet
émetteur ne doit pas être co-localisées ou opérant en conjonction avec une autre antenne ou transmetteur.
3
I
NTRODUCTION