Exmark Lazer Z Operator's Manual page 57

6. Insert the height adjustment pin into the 3 inch
(7.6 cm) cutting height location.
7. Release the transport lock and allow the deck to
lower to the cutting height.
8. Raise the discharge deflector (side discharge units
only).
9. Measure from the level surface to the front tip of
the center blade. The measurement should read
3 inches (7.6 cm).
Note: In most conditions, the back tips on the
side blades should be adjusted:
Side Discharge Units: 1/4 inch (6.4 mm) higher
than the front.
Rear Discharge Units: to be level with the front.
1. Side Discharge: 3 1/4 inches (8.3 cm)
Rear Discharge: 3 inches (7.6 cm)
2. Back blade tip
3. Front blade tip
4. 3 inches (7.6 cm)
5. Level surface
10. Adjust the height — to increase, turn the
adjuster screw clockwise; to decrease, turn
counterclockwise.
• X-Series:
Loosen the jam nuts on the top of each deck
adjuster. Fine tune the adjuster on the front
deck lift assembly by turning it to get 3 inch
(7.6 cm) height (see Figure 41).
Figure 40
1. Adjuster link
2. Jam nut
• S and E-Series:
Fine tune the front deck lift assembly by
turning the adjuster screw until it reaches the
3 inch (7.6 cm) height (see Figure 42).
g009997
1. Adjuster screw
11. Measure the back tip height. Fine tune rear
adjusters as required; the single point adjustment
can be utilized to gain more adjustment.
57
Maintenance
Figure 41
3. Adjuster
Figure 42
2. Jam nut
g011839
g012075