Mobil Hts Grease (Or Food-Grade Anti-Seize)X-Series Only; Copper-Based Anti-Seize; Dielectric Grease; Adjustments - Exmark Lazer Z Operator's Manual

Maintenance
• Hydro pump control arm, linkage bolt, and
attachment bolt.
• Hydro cooling fan screw.
• Hydro park brake anchor mounting bolt
• Sheave and clutch retaining bolt in the end of
engine crankshaft.
Thread locking adhesives are required for some
hardware on engines — see the Engine manual.
Mobil HTS Grease (Or
Food-Grade Anti-seize)
X-Series Only
Mobil HTS grease (or food-grade anti-seize) is used
in the following location:
Between the spindles and bearings.

Copper-Based Anti-seize

Copper-based anti-seize is used in the following
location:
On threads of Blade Bolts. See Check Mower
Blades section.

Dielectric Grease

Dielectric grease is used on all blade type electrical
connections to prevent corrosion and loss of contact.
Dielectric grease should not be applied to sealed
connectors.

Adjustments

Note: Disengage PTO, shut off engine, wait for
all moving parts to stop, engage parking brake, and
remove key before servicing, cleaning, or making any
adjustments to the unit.
CAUTION
Raising the mower deck for service or
maintenance relying solely on mechanical
or hydraulic jacks could be dangerous. The
mechanical or hydraulic jacks may not be enough
support or may malfunction allowing the unit to
fall, which could cause injury.
Do Not rely solely on mechanical or hydraulic
jacks for support. Use adequate jack stands or
equivalent support.

Deck Leveling

1. Position the mower on a flat surface.
2. Stop engine, wait for all moving parts to stop, and
remove key. Engage parking brake.
3. Check the tire pressure in drive tires and
pneumatic front caster tires (if equipped). Proper
inflation pressure for tires is 13 psi (90 kPa).
Adjust if necessary.
4. Position the transport lock in the latching
position.
5. Push the foot pedal all the way forward and the
deck will latch at the 5 1/2 inch (14 cm) transport
position (Figure 39).
1. Foot pedal
2. Height of cut pin
56
Figure 39
3. Transport lock
g030145