Exmark Lazer Z Operator's Manual page 28

Operation
Figure 5
1. Neutral lock position
(handles out)
2. Neutral operate position
(handles in)
3. Front of Unit
Choke Control (Non-EFI or RED
Equipped Models)
Located on right console (black lever) (see Figure 6).
The choke is used to aid in starting a cold engine.
Moving the choke lever forward will put the choke in
the "ON" position and moving the choke lever to the
rear, to the detent, will put the choke in the "OFF"
position. Do Not run a warm engine with choke in
the "ON" position.
g008593
4. Forward
5. Neutral (operate)
6. Reverse
1. Fuses
2. Message display
3. Ignition switch
Throttle Control
(All Units Except RED Equipped
Units)
Located on right console (red lever) (see Figure 6 and
Figure 7).
The throttle is used to control engine speed. Moving
the throttle lever forward will increase engine speed
and moving the throttle lever to the rear will decrease
engine speed. Moving the throttle forward into the
detent is full throttle.
1. Fuses
2. Message display
3. PTO engagement switch
28
Figure 6
4. PTO engagement switch
5. Throttle
6. Choke
Figure 7
4. Ignition switch
5. Throttle
g223866
g223877