Filling Up With Chain Oil - Stihl HTA 65 Instruction Manual

English
► If a Carving guide bar is used: Turn the tensioning screw
(2) clockwise until the drive links on the underside of the
bar are just half visible.
► Hold the bar nose up and tighten down the nut (1) firmly.
► If chain sag 'a' in the center of the bar is not 1 - 2 mm:
Readjust chain tension.
► If you use a Carving bar and the drive links on the
underside of the bar are less than half visible: Readjust
chain tension.
7.3

Filling Up with Chain Oil

Chain oil lubricates and cools the rotating chain.
► Switch off the pole pruner, push retaining latch to position
and remove the battery.
► Place pole pruner on a level surface so that the oil tank
cap faces up.
► Use a damp cloth to clean the tank cap and the area
around it.
► Swing the grip on the oil tank cap to the vertical position.
► Turn the oil tank cap counterclockwise as far as stop.
► Remove the oil tank cap.
► Fill up with chain oil, taking care not to spill any oil and do
not overfill the tank.
► If the grip on the oil tank cap has dropped into the closed
position: Raise the grip until it is vertical.
56
1
2
► Place the cap in the filler opening so that mark (1) lines up
with mark (2).
► Press the cap down and rotate it clockwise as far as stop.
The cap snaps into place. The mark (1) points to mark (3),
► Check to see if the oil tank cap can be pulled upwards and
off.
► If the oil tank cap cannot be pulled upwards and off: Fold
down the grip on the oil tank cap.
The oil tank is closed.
If the oil tank cap can be pulled upwards and off, perform the
following steps:
► Place the oil tank cap in the filler opening – in any position.
► Press the cap down and rotate it clockwise as far as stop.
► Press the cap down and rotate it counterclockwise until
mark (1) points to mark (2).
► Now try again to close the oil tank.
7 Assembling the Pole Pruner
1
3
2
0458-766-9921-B
1