Starting The Pdt 7500; Calibrating The Screen - Symbol PDT 7500 Series Product Reference Manual

®
PDT 7500 Series Product Reference Guide for Windows CE

Starting the PDT 7500

After installing and charging the battery, start the terminal by pressing the red Power button.
If the terminal does not power on, perform a hard reset. See Booting the Terminal on page 3-
4.
Power
Button
Figure 3-1. Power Button
As the terminal initializes, the Symbol splash screen displays for about a minute.

Calibrating the Screen

The first time you start your PDT 7500 (and whenever the terminal is cold-booted) the
calibration screen appears. This section describes how to calibrate your PDT 7500 so the
cursor on the touch screen aligns with the tip of your stylus.
Note: If your PDT 7500 unit came loaded with another software
application, the calibration screen may not appear.
To calibrate your PDT 7500:
1. If necessary, adjust the contrast on the PDT 7500 so the screen is clear and readable.
3-2