TRENDnet TL2-E284 Quick Installation Manual page 8

Note:
A terminal program such as HyperTerminal is required to configure the switch via the Console Port.
The instructions shown below demonstrates how to configure the Switch on a W indows PC using
HyperTerminal.
1. Connect the RS-232 cable from a serial port on
your PC to the console port on the switch.
2. Go to Start ^ Programs ^ Accessories ^
Communications ^ HyperTerminal
3. Enter a name, choose an icon and then click
OK.
4. Select the correct COM port
(e.g. COM1, COM2) and then click OK.
r ' T T T 1 r ' T T T 1 r T T T 1 : U r j
L i i i J L i i i J L i i i J
6
u
n n
HyperTerminal