TRENDnet TL2-E284 Quick Installation Manual page 12

Hide thumbs Also See for TL2-E284:

2. I typ e d http://192.168.10.200 in m y In te rn et B ro w s e r's A d d re s s Bar, b u t an e rro r m essage

sa ys " The page c a n n o t be d is p la ye d ." H ow can I g e t in to th e TL2-E284's w eb c o n fig u ra tio n

page?

1, Check your hardware settings again by following the instructions in section 2,

2, Make sure the PWR(Power), SYS(System) and Link/ACT lights are lit,

3, Make sure your network adapter's TCP/IP settings are configured properly (see Q1),

4, Since the Switch's default IP address is 192,168,10,200, make sure that no other network

devices are assigned an IP address of 192,168,10,200,

3. If m y s w itc h 's IP is d iffe re n t th a n th e n e tw o rk's su b n e t, w h a t s h o u ld I do?

You should still configure the Switch first, A fter all the settings are applied, go to the Switch's

configuration page, click on Administrator, click IP & Management Mode and change the IP

address of the Switch to match your network's IP.

4. W h a t are th e d e fa u lt p o rt s e ttin g s fo r c o n fig u rin g th e S w itch th ro u g h th e co n s o le po rt

u sin g H yperTerm inal?

Bits per Second: 115200; Data bits: 8; Parity: None; Stop bits: 1; Flow control: None,

5. I ch anged th e IP a d dress o f th e sw itch , b u t I fo rg o t it. H ow d o I reset m y TL2-E284?

Follow the instructions below:

1, Take a pin or paper clip and press the reset button on the front of the switch

2, Wait 15 seconds then let go,

The default IP address of the switch is 192,168,10,200, The default user name and password

is admin,

6. H ow d o I enable Telnet on m y W in d ow s 7/Vista co m p u ter?

Follow the instructions below:

W indows 7

1, Go to Control panel and click Programs,

2, Click Turn W indows features on or off,

3, Check the box next to Telnet client and then click OK,

4, Please wait while W indows enables Telnet,

W indows Vista

1, Go to Control Panel and click on Classic View,

2, Click on Programs and Features,

3, C lick Turn W indows features on or off,

4, Check the box next to Telnet Client and then click OK,

5, Please wait while W indows enables Telnet,

If you still encounter problems or have any questions regarding the TL2-E284 please contact

TRENDnet's Technical Support Department,

Table of Contents