Setting Up The Gigaset Se551 Wlan Dsl/Cable - Siemens gigaset SE551 Owner's Manual

Wlan dsl/cable
Hide thumbs Also See for gigaset SE551:
Table of Contents

Advertisement

First Steps
u
Reboot function: Press the button for longer than 1 second but less than 5 seconds
to reboot the device. This does not affect the configuration settings.
u
Reset function: Press the button behind the small opening on the bottom of the
device for at least 5 seconds to return all settings to the factory settings.
Warning: This will clear all the configuration settings you have made.
Updated firmware will not be affected.

Setting up the Gigaset SE551 WLAN dsl/cable

The Gigaset SE551 WLAN dsl/cable can be set up in any suitable location in your home
or office. You do not need any special wiring. However you should comply with the fol-
lowing guidelines:
u
Operate the Gigaset SE551 WLAN dsl/cable only indoors within a temperature range
of +5 to +40 °C. Do not position the Gigaset SE551 WLAN dsl/cable near sources of
heat. Do not cover the ventilation slots. High temperatures can damage the device.
u
A mains socket for 220/240V~ and a connection socket for the modem or LAN must
be available where you set up the Gigaset SE551 WLAN dsl/cable.
u
Do not site the device in the immediate vicinity of stereo equipment, TV sets or
microwave ovens. This may cause interference.
u
Position the Gigaset SE551 WLAN dsl/cable so that it is as near to the centre of your
wireless network as possible. Make sure that where you position the Gigaset SE551
WLAN dsl/cable has optimum reception throughout the house or office. You can
improve the reception quality by aligning the antenna (turn and/or tilt).
u
Position the Gigaset SE551 WLAN dsl/cable on a non-slip surface. The router feet do
not normally leave any traces on the surface they are on. However, some furniture
surfaces may contain substances that attack and soften the router's rubber feet.
Then the feet may well mark the furniture surface.
u
Do not place the Gigaset SE551 WLAN dsl/cable on any furniture surface that could
be affected by the heat from the device.
u
Position the Gigaset SE551 WLAN dsl/cable so that it cannot fall.
u
Lay the cables so that nobody can trip over them.
u
If you wish to mount the Gigaset SE551 WLAN dsl/cable on the wall, use flat-headed
or tallow-drop screws with a maximum thread diameter of 3.5mm. The screws are
not included in the scope of delivery.
18

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents