Rfc2684 - Siemens 4100 Series User Manual

Router User's Guide

RFC2684

The SpeedStream Router supports two basic types of connections: Point-to-Point (PPP) and RFC2684.
By default, RFC2684 connections rely on a server located on the Wide Area Network (WAN) to supply the
Router a dynamic IP address and other IP-based configuration parameters for the Router's WAN-side
interface. To accomplish this, the Router executes a Dynamic Host Configuration Protocol (DHCP) client
associated with the WAN-side connection. This client, in turn, communicates with the DHCP server
located on the WAN.
Under some circumstances, this automated procedure may not be desirable or even possible. In such
situations, you will need to disable the DHCP client on the router and manually define the required IP
configuration parameters, as supplied by your service provider.
To configure RFC2684 functionality:
1. Select Setup>RFC2684 from the left navigation pane of the Web interface. This displays the
"RFC2684 Configuration" window.
2. Select the connection you want to configure from the Connection drop-down menu.
3. Select one of the following from DHCP:
• Enabled
Enables the Dynamic Host Configuration Protocol for the selected connection.
• Disable
Disables the Dynamic Host Configuration Protocol for the selected connection.
4. In IP Address, enter the IP address to be used for the WAN-side of the Router, normally obtained
from a DHCP server located on the WAN.
5. In IP Netmask, enter the netmask corresponding to IP Address.
6. In Default Gateway, optionally enter the IP address of a router located on the WAN to be used as the
"gateway" to the WAN.
7. In DNS Server, optionally enter the IP address of a DNS server located on the WAN to be used to
resolve domain name/IP addresses.
8. Click Save.
30
Configuring Network Settings