Figure 7-6 Sealing Gap Between Enclosure And End Shields - Siemens 1PH728 Operating Instructions Manual

NOTICE
Note that these joints between parts (e.g. the sealing gap between the enclosure and end
shield) must also be resealed with a suitable, silicone-free sealant during assembly.
Figure 7-6
①
②
③
④
● Before you screw on the end shields, seal the gap ② with MARSTON HYLOMAR SQ32M
A5E00177602A AD
Siemens AG Operating Instructions 2.02 1PH728
Siemens Hardware
Sealing gap between enclosure and end shields
End shields
Sealing gap
Housing
Protective tube
sealant.
NOTICE
Check the sealing elements fitted (e.g. at the terminal boxes) and replace them if they
do not provide an adequate seal.
Maintenance
7.3 Corrective Maintenance
63