Table of Contents
Advertisement
82
Problem
Error message "Down-
load error" appears
while you are down-
loading Java™ applica-
tions
Application-specific er-
ror message appears
during data transfer
from online Java™ ap-
plications
™
MultiMediaCard
cannot be read.
™
MultiMediaCard
cannot be written to.
No connection to the
network
Phone loses network.
Calls not possible
Certain uses of the
phone not possible
Troubleshooting
Possible causes
Java™ standard Dial-in Ac-
cess is configured incorrectly.
Java™ standard Dial-in Ac-
cess is configured incorrectly.
Incorrect format, contacts
dirty
™
MultiMediaCard
write-
protected
Signal weak
Outside GSM range
SIM card not valid
New network not authorized Try manual selection or select different network
Network barring is set
Network overloaded
Signal too weak
Dialling error
2nd line set
New SIM card inserted
Charge limit reached
Call restrictions are set.
The phone number has more
than 20 digits.
Possible remedy
Configure the Java™ standard Dial-in Access cor-
rectly (see p. 69).
Configure the Java™ standard Dial-in Access cor-
rectly (see p. 69).
1. Remove and replace MultiMediaCard™.
2. Clean contacts.
3. Switch the phone off and on again.
4. Format the MultiMediaCard™ (you will lose all
the data on the card).
Replace the MultiMediaCard
Move higher, to a window or open space.
Check Service Provider coverage map.
Use another phone to contact Service Provider.
(see p. 67).
Check barrings (see p. 67).
Try again later.
Reconnection to another Service Provider is auto-
matic (see p. 67). Switching the phone off and on
again may speed this up.
New network not authorised (see p. 67).
Set other call line (see p. 66).
Check for new restrictions.
Contact Service Provider or reset limit with PIN 2
(see p. 59).
Barrings may be set by your Service Provider. Check
barrings (see p. 66).
Check phone number.
™
.
Advertisement
Table of Contents
