JVC KD-SH1000 Instruction Manual page 272

• Noise is generated.
• "File Check" keeps flashing on the display.
• "No Files" appears on the display.
• "Not Support" appears on the display and
track skips.
• "Read Failed" appears on the display, then
returns to the previous source.
• "SD Loading Error" appears on the display
while playing tracks from an SD card.
• While playing a track, sound is sometimes
interrupted.
• Correct characters are not displayed (e.g.
album name).
• "No Disc" appears on the display.
• "No Magazine" appears on the display.
• "Reset 8" appears on the display.
• "Reset 1" – "Reset 7" appears on the display.
• The CD changer does not work at all.
• DSP mode cannot be selected other modes
than "Defeat."
• Only high range sound or low range sound is
reproduced though full range speakers are
connected.
40
All manuals and user guides at all-guides.com
Symptoms Remedies/Causes
The track played back is not an MP3/WMA track. Skip to
another file. (Do not add the extension code <.mp3> or
<.wma> to non-MP3 or WMA tracks.)
• Readout time varies depending on the device.
• Do not use too many hierarchy and folders.
• Turn off the power then on again.
Play a device that contains tracks encoded in an
appropriate format.
The track is unplayable.
• The device may be malfunctioning, or may not have
been formatted correctly.
The files included in the device are corrupted.
• Do not pull out or attach the USB memory repeatedly
while "File Check" appears on the display.
Detach the control panel and reinsert the SD card. The
control panel goes back to initial position (Angle 1).
MP3/WMA tracks have not been properly copied into the
device.
Copy MP3/WMA tracks again into the device, and try
again.
This unit can only display letters (capital: A – Z, small:
a – z), numbers, and a limited number of symbols and
special characters (see page 26).
Insert a disc into the magazine.
Insert the magazine.
Connect this unit and the CD changer correctly and press
the reset button of the CD changer.
Press the reset button of the CD changer.
Reset the unit (see page 2).
Deactivate crossover network (see page 21).