Work Place Inspection - Genie S-120 Operators Manual With Maintenance Information

First Edition · Fourth Printing
Do Not Operate Unless:
You learn and practice the principles of safe
machine operation contained in this operator's
manual.
1 Avoid hazardous situations.
2 Always perform a pre-operation
inspection.
3 Always perform function tests prior to use.
4 Inspect the work place.
Know and understand the above principles
before going on to the next section.
5 Only use the machine as it was intended.
Fundamentals
The Work Place Inspection helps the operator
determine if the work place is suitable for safe
machine operation. It should be performed by the
operator prior to moving the machine to the work
place.
It is the operator's responsibility to read and
remember the work place hazards, then watch for
and avoid them while moving, setting up and
operating the machine.
Part No. 62756

Work Place Inspection

Work Place Inspection
Be aware of and avoid the following hazardous
situations:
· drop-offs or holes
· bumps, floor obstructions or debris
· overhead obstructions and high voltage
conductors
· hazardous locations
· inadequate surface support to withstand all load
forces imposed by the machine
· wind and weather conditions
· the presence of unauthorized personnel
· other possible unsafe conditions
Genie S-120 & Genie S-125
Operator's Manual
21