Dell DSS 2500 Owner's Manual page 99

Figure 42. Installing the internal PERC riser
1 internal PERC riser module
3 internal PERC riser
5 PCIe connector on system board
Next steps
1 Reconnect all disconnected cables.
2 Install the cooling shroud.
3 If removed, reinstall the full length expansion card.
4 If required, open the expansion card latch on the cooling shroud to support the full length expansion card.
5 Follow the procedure listed in the After working inside your system section.
Related links
Safety instructions
Before working inside your system
Removing an expansion card from the internal PERC riser
Removing the cooling shroud
Removing the internal PERC riser
Installing the cooling shroud
Installing an expansion card into the internal PERC riser
After working inside your system
2 guide slot on the internal PERC riser (2)
4 guide pin on the chassis (2)
Installing and removing system components 99