Dell DSS 2500 Owner's Manual page 47

Option Description
External Serial
Enables you to associate the External Serial Connector to Serial Device 1, Serial Device 2, or the Remote Access
Connector
Device by using this option.
Failsafe Baud Rate Specifies the failsafe baud rate for console redirection. The BIOS attempts to determine the baud rate
automatically. This failsafe baud rate is used only if the attempt fails, and the value must not be changed. This
option is set to 115200 by default.
Remote Terminal Sets the remote console terminal type. This option is set to VT 100/VT 220 by default.
Type
Redirection After Enables or disables the BIOS console redirection when the operating system is loaded. This option is set to
Boot Enabled by default.
Related links
Serial Communication
Viewing Serial Communication
System Profile Settings
You can use the System Profile Settings screen to enable specific system performance settings such as power management.
Related links
System Profile Settings details
System BIOS
Viewing System Profile Settings
Viewing System Profile Settings
To view the System Profile Settings screen, perform the following steps:
1 Turn on, or restart your system.
2 Press F2 immediately after you see the following message:
F2 = System Setup
NOTE: If your operating system begins to load before you press F2, wait for the system to finish booting, and then restart
your system and try again.
3 On the System Setup Main Menu screen, click System BIOS.
4 On the System BIOS screen, click System Profile Settings.
Related links
System Profile Settings
System Profile Settings details
System Profile Settings details
The System Profile Settings screen details are explained as follows:
NOTE: Every time the system boots, the BIOS syncs the serial MUX setting saved in iDRAC. The serial
MUX setting can independently be changed in iDRAC. Loading the BIOS default settings from within the
BIOS setup utility may not always revert the serial MUX setting to the default setting of Serial Device 1.
NOTE: Only Serial Device 2 can be used for Serial Over LAN (SOL). To use console redirection by SOL,
configure the same port address for console redirection and the serial device.
NOTE: Every time the system boots, the BIOS syncs the serial MUX setting saved in iDRAC. The serial
MUX setting can independently be changed in iDRAC. Loading the BIOS default settings from within the
BIOS setup utility may not always revert this setting to the default setting of Serial Device 1.
Pre-operating system management applications 47