Table of Contents
Advertisement
Top Cover
If the top cover is being replaced, the control
panel assembly and the water valve will need
to be removed. If the top cover is not being
replaced, the water valve does not have to be
removed.
1. Remove the two 5/16 hex head screws that
secure the harness and power cord ground
screws to the top cover.
Ground Screws
Main Harness
Grommet
2. Slide the main harness grommet toward the
rear of the washer.
3. Remove the power cord by applying upward
pressure to the cord in front of the grommet.
Slide the grommet forward to release it from
the top cover.
Basket Assembly
The basket assembly consists of the balance
ring, basket side wall and the basket bottom. The
hub is molded into the basket bottom.
Basket Removal
1. Remove the backsplash and top cover
assemblies.
2. Remove the tub cover by unclasping eight
3. Remove the hub nut and conical washer. The
hub nut is reverse threads. It will need to be
turned to the right to loosen.
4. Lift the basket out from the tub. The basket
assembly weight is approximately 21 pounds.
A torque limiter (Part #: WX05X10028) should be
used when removing or installing the hub nut with
an impact gun.
– 39 –
Clips
Hide quick links:
Advertisement
Table of Contents
