Platform/Transmission Assembly - GE GTW750CPLDG Technical Service Manual

2. Remove two 3/8 hex bolts securing the mode
shifter to the platform. The mode shifter,
away from the platform.
Mode Shifter Reinstallation
1.
transmission shaft.
2. Install the clutch spring.
3. Slide the clutch into the clutch level of the
mode shifter and slide the clutch onto the
shaft. There are guide pins on the bottom of
the mode shifter that go into locator holes on
the platform.
4. Install the two 3/8 hex bolts and torque to 60
in. pounds.
Clutch
Clutch
Spring
Flat
Washer

Platform/Transmission Assembly

The platform assembly not only houses the
transmission, but is used to mount the drive
motor and mode shifter. The transmission has
planetary gears inside to assist with the agitation
and spin cycles of the washer. It is one complete
part with the exception of the two harness
mounting brackets (some models have one
harness mounting bracket) and a motor splash
guard.
Platform/Transmission Removal
1. Remove the impeller or agitator to access the
2. Remove the hub nut and Belleville washer.
3. Lean the washer back or lay the washer on its
After all other components have been removed
from the platform assembly:
4. Cut the wire ties that support the main
Guide
5. Remove the 3/8 hex bolts securing the
Pins
Locator Holes
6. Remove the eight 3/8 hex bolts securing the
7. Pry the platform assembly away from the tub.
– 57 –
hub nut.
The hub nut has reverse threads, and needs
to be turned clockwise to loosen.
side to access the bottom.
harness to the platform assembly.
motor shield and the harness brackets to the
platform.
platform to the bottom of the tub.
(Continued next page)