Sherwood RD-6513 Operating Instructions Manual page 37

RD-6513(A) 2008.8.21 12:20 PM 페이지 38
When selecting the CROSSOVER
• When speakers are set to "S (Small)", be sure to set their crossover frequency correctly according to their frequency
characteristics.
1.
Press the CURSOR UP(▲)/DOWN(▼) buttons to select the "X-OVER", then press the ENTER button.
2.
Press the CURSOR LEFT(◀)/RIGHT(▶) buttons to set the crossover frequency as desired.
About the crossover frequency
• When speakers are set to "S (Small)", low frequencies in those channels that are below the crossover frequency are to
output from subwoofer or front speakers which are set to "L (Large)" (when not using a subwoofer).
• Refer to the operating instructions of the speakers to be connected. If the frequency range of your speaker is 100 Hz~20
kHz, the crossover frequency should be set to 100 Hz(or slightly higher).
• You can adjust the crossover frequency within the
range of 40 ~ 130 Hz in 10 Hz intervals.
38