Sherwood RD-6500 Operation Instructions Manual page 21

Select the desired preset number (1~30) and
press the MEMORY/ENTER button.
3
TUNING/PRESET
• When using the NUMERIC buttons on the remote
control.
3
Examples) For "3" :
1
For "15" :
0
For "30" :
• The station has now been stored in the memory.
• When using the NUMERIC buttons, the station is
stored automatically without pressing the
MEMORY/ENTER button.
• A stored frequency is erased from the memory by
storing another frequency in its place.
• If "MEM" goes off, start again from the above step 2.
Tuning to preset stations
After selecting the tuner as an input
source, select the preset tuning mode.
1
T/P MODE
• Then "PRESET" lights up.
Listening to FM stereo broadcasts
• While listening to FM broadcasts.
• Each time this button is pressed,
the FM mode changes as follows;
Stereo mode : "ST" lights up.
Mono mode : "ST" goes off.
• When FM stereo broadcasts are poor because of weak
broadcast signals, select the FM mono mode to reduce
the noise, then FM broadcasts are reproduced in
monaural sound.
MEMO/ENTER
within 2 seconds 5
FM MODE
21
Repeat the above steps 1 to 3 to memorize
other stations.
4
MEMORY BACKUP FUNCTION
The following items, set before the receiver is turned
off, are memorized.
• INPUT SELECTOR settings
• Surround mode settings
• Preset stations,etc.
Note : If the electricity fails or the AC input cord is
disconnected for more than 2 weeks, they are all
cleared. So you should memorize them again.
Select the desired
preset number.
2
• When using the NUMERIC buttons on the remote
control.
3
Examples) For "3":
1
For "15":
0
For "30":
• When selecting the desired preset number with the
NUMERIC buttons, the desired preset station will be
tuned to automatically without selecting the preset
tuning mode.
Scanning preset stations in sequence
POWER DISPLAY SLEEP VIDEO1
1 2 3 VIDEO2
4 5 6 VIDEO3
7 8 9 CD
T.TONE 0 P.SCAN TUNER
DSP MODE D.TIME ADJUST AUX
AUTO CH. SEL MUTE T.MON
CH. LEVEL MASTER VOLUME
REMOTE CONTROL UNIT RM-105
• The receiver will start scanning the stations in the preset
sequence and each station is received for 5 seconds.
• At the desired station, press this button again to stop
scanning.
TUNING/PRESET
within 2 seconds 5
3 0
within 2 seconds
(or )
P.SCAN